Pool Equipment Repair in Georgetown, TX

Valves direct where your water goes, and a stuck or leaking valve sends it to the wrong place or drops your pool level fast. We rebuild and replace diverter valves, multiport valves, and check valves so water flows to the right returns at the right pressure. A multiport valve that channels to waste by accident can drain a pool overnight, so we treat valve leaks as a priority. Most valve problems are straightforward when they are caught early.

We replace worn gaskets and handles, free up stuck stems, and reseal the valve body so the system holds pressure. For valves that are too far gone, we install a quality replacement that fits your brand. Getting the valves right is what lets your pump, filter, and cleaner each do their job.

A pool cleaner that sits still or misses half the pool usually has a worn part or a flow problem rather than a dead unit. We diagnose suction, pressure, and robotic cleaners and fix the part that is actually stopping them. Suction cleaners often need a foot pad or a diaphragm, while pressure cleaners may need a backup valve or a worn drive track. Getting the right part is what gets the cleaner covering the whole pool again.

We also check the hose length, the suction line, and the return flow, because a cleaner problem is sometimes a circulation problem in disguise. We test the cleaner in the water before we call the job done, so you can see it moving the way it should. A working cleaner is one of the easiest ways to keep debris off the floor between visits.

A salt chlorine generator that stops producing leaves the water dull and open to algae, and the cause is usually a scaled cell, a worn flow switch, or a control board issue rather than a dead unit. We clean and descale salt cells from Hayward and Pentair, dissolving the calcium and mineral buildup that chokes the plates and cuts chlorine output. Central Texas hard water scales cells faster than softer water does, so a regular clean is what keeps the generator producing at full strength. We test the cell, the flow, and the output before we recommend a replacement, because a descale is often the only fix the system needs.

When a cell has reached the end of its lifespan, we match a genuine replacement to your generator model and your plumbing, and we calibrate the output so the chlorine stays in range without overworking the cell. We also check the flow switch and the sensor connections, because a salt system that reads low salt when the level is fine is usually a sensor problem rather than a water problem. We verify the chlorine production before we call the job done, so you can see the cell is generating again. A working salt system is one of the easiest ways to keep balanced, swim-ready water with less daily attention.

Our first move is always to see whether a part can be saved, because a seal, a gasket, or a reprogram is often all an older piece of equipment needs. We diagnose the actual failing part and give you an honest read on whether a repair will hold or whether a replacement is the smarter long call. When a repair costs more than the part is worth, we tell you straight up instead of patching something that will fail again. We give a free written quote after seeing your situation, no pressure, so you can decide what works for your home.

When a replacement is the better path, we recommend equipment that fits your existing pad, your plumbing, and your pump, so the swap is clean and the new part works with what you already own. We install quality parts for your brand and run the full system through a cycle before we leave. Repairs and replacements are separate from weekly cleaning, and we lay out the plan clearly so there are never surprise charges. The goal is equipment that runs quietly and reliably for the long haul.